WTS: Greek EBO lower housings, HK33/93 slimline, EBO lower complete

Thanks for looking...I have a few stripped EBO lower housings, no grips, no selectors, not clipped or pinned.

I have two original lowers, #1 has a few dings near the EBO logo, they are marked in the third photo. It seems to have been dinged hard enough to dimple the inside of the housing to about the size of a dime. I have not tried to install a FCG but I'm sure it would be very snug to almost impossible to get one in without correcting the matter. Also there is a bad place on the ear where the push pin would go through.
$25 shipped lower 48

#2 is better, normal surplus wear and tear. $40 shipped lower 48





Bad spot on the ear is visible here. The middle arrow points to the dimple.




#3 is another stripped housing that was blasted and refinished, the coloring on the numbers (enamel based) is meh!... lets say it could have been better, there has been some touch up done. It looks good at arms length.
$55 shipped to lower 48




This lower is complete and has been refinished (not clipped or pinned). Not much to say, I'll let the photos do the talking. (color fill is enamel based)
$135 shipped lower 48


HK33/93 slimline handguard, looks very presentable with the exception of a small area (marked).
$175 shipped lower 48




Please post an "I'll take it" here followed by a PM. I will gladly answer any questions you have, but if someone post they'll take it in the thread before I can get back to you ...I have to go with it.

Payment can be made with (discreet) PayPal +3.5% or USPS money order.
Thanks!