LEM HK45 going back to V1

Hello,

A few months ago I got my first HK. It was purchased here on the forums and came with the LEM trigger installed. It also came with the parts to convert back to V1. I shot a bit with the LEM kit, however, I'd like to return to the V1. I like the idea of having the decocker and also the safety.

So, tonight, I embarked on the journey of disassembling and going back to V1. I used youtube references and the HK45 manual exploded parts schematic as a guide to reassemble. I just want to make sure I did all this correctly. I have a few parts left over from the LEM kit (see attached photo). The rest of the parts were either in the V1 kit or were reused. The pistol seems to function properly. I've run some snap caps through it, the functionality seems OK. The only thing the decocker seems awfully loud (much louder than when the hammer actually strikes). However when decocking, I can tell a difference between how far the hammer travels (does not travel all the way as compared to firing).

Attachment 22581

Also, the V1 kit didn't include the spring. I ended up using the LEM main spring. Is that acceptable? I don't have any part numbers unfortunately.

Attachment 22582

Thanks for helping a new guy out. :redface:

Attached Thumbnails